Flightdek-d180 manual

The FlightDEK-D incorporates state-of-the-art EFIS electronics design. The primary functions provided include attitude, airspeed, altitude, vertical speed, gyro-stabilized magnetic compass, slip/skid ball, turn rate, clock, timers and g-meter. IF YOU OWN ONLY A FLIGHTDEK-D Connect the SL30 unit to pin 22 on the EFIS DB25 connector, and the GPS to pin 19 on the EMS DB37 connector. You can display either source on the HSI using the softkeys. You will need to disconnect the SL30 from the EFIS when doing software updates. IF YOU OWN A FLIGHTDEK-D AND AN EFIS. EFIS portion of the FlightDEK-D Because of this high degree of commonality between the various EMS units, the term EMS will be used to refer to connections related to the EMS-D10, EMS-D, and the EMS portion of the FlightDEK-D It is intended that this guide is distributed electronically (PDF format) and the installer print out.

When my new Carbon Cub arrived magnetic heading on my Dynon FlightDEK was way off. So I dove into the FlightDEK-D installation manual and found the remote compass calibration instructions. Then found a compass rose and went through the full compass calibration. Everything seemed to check out on the ground but once back up in the air north south readings were better but east west. Dynon Avionics FlightDEK-D Installation Manual Installation manual ( pages) Globalsat ER Specifications Specifications (13 pages) Dynon Avionics EMS-D10 User Manual Operation user's manual (53 pages). FlightDEK-D Pilot's User Guide The FlightDEK-D can be ordered with an optional internal battery which allows the instrument to continue to operate in the event of an external power failure. This lithium-ion battery is rechargeable and is managed by the FlightDEK-D If the always-on Keep Alive circuit is connected, the FlightDEK.

The FlightDEK-D incorporates state-of-the-art EFIS electronics design. The primary functions provided include attitude, airspeed, altitude, vertical speed, gyro-stabilized magnetic compass, slip/skid ball, turn rate, clock, timers and g-meter. The FlightDEK-D should display an alert regarding DSAB connectivity. Additionally, the AP Status display should show AP:ERR:ERR. Page Alerts In an alarm condition, the FlightDEK-D also alerts you audibly, provided the EMS Audio Alert output is connected to your intercom as described in the FlightDEK-D Installation Guide. This section provides a general overview of the various parts of the FlightDEK-D as well as a theory of operation. The information in this section serves as a reference only and helps familiarize you with the inner workings of the unit.